The electronic balance and electronic analytical balance have automatic fault detection, external weight, automatic calibration, all linear four-point calibration, overload protection and other applications. The following are the operating procedures of the balance:
Electronic balance
1. Check if the balance is level, observe the level, such as the level blister shift, adjust the level adjustment foot so that the level is at the center of the level.
2. Open the side doors on both sides for 5 to 10 minutes to balance the humidity and temperature inside and outside the balance, and avoid the side door due to the difference in humidity and temperature between the inside and outside of the balance cover.
3. Check if the balance is clean. If there is dust, apply a brush to clean it.
4. Turn on the power and turn on the display after warming up for one hour.
5. Select the weighing mode and perform weighing.
6. Press the TAR button to display the zero layer, set the object and the disk, and wait until the number is stable (after the “0†mark on the left side of the display goes out). This number is the mass value of the object.
7. After the weighing is completed, take out the weighed object, close the balance door, close the display, cover the dust cover, and register.
Precautions for use:
1. The balance should be used with care. The pan and outer casing are often gently scrubbed with a soft cloth and toothpaste. Do not scrub with strong solvent.
2. Do not weigh the overcooled and overheated items on the balance. Weigh the objects and the balance chamber and weigh them.
3. The silica gel desiccant should be placed in the balance frame, and the desiccant blue should disappear in time after disappearing.
4. If the balance is not used for a long time, the power cord should be removed.
5. After the weighing is completed, remove the so-called items in time and keep the balance clean.
6. The balance load shall not exceed the maximum load, and the scale shall be weighed in a dry and clean vessel.
Medical Cold Patch
Patch for diarrhea
[Name] Medical Cold Patch
[Package Dimension] 5cm 4pieces/box
The pain relief patch is composed of three layers, namely, backing lining, middle gel and protective film. It is free from pharmacological, immunological or metabolic ingredients.
[Scope of Application] For cold physiotherapy, closed soft tissue only.
[Indications]
The patches give a fast relief for diarrhea.
[How To Use a Patch]
Please follow the Schematic Diagram. One piece, one time.
The curing effect of each piece can last for 6-8 hours.
[Attention]
Do not apply the patch on the problematic skin, such as wounds, eczema, dermatitis,or in the eyes. People allergic to herbs and the pregnant are advised not to use the medication. If swelling or irritation occurs, please stop using and if any of these effects persist or worsen.notify your doctor or pharmacist promptly. Children using the patch must be supervised by adults.
[Storage Conditions]
Store below 30c in a dry place away from heat and direct sunlight.
Patch For Diarrhea,Medicated Patches For Arthiritis,Plaster For Diarrhea,Pad For Diarrhea
Shandong XiJieYiTong International Trade Co.,Ltd. , https://www.xjpatches.com