Root carving handicrafts are high-end artworks and are deeply loved by people. The pot rack made in the form of root carvings displays a variety of bonsai flowers that are rare, simple, and of high value. Root carving pot racks are expensive, but after all, root collection is not easy, and root carving materials are limited. Can root pot racks be imitated to form mass production? can. The production method is as follows: 1. Select the tire mold. The tire mold is very important, it determines the artistic value of the imitative root carving work. The roots of the tire mold should be those natural and natural materials that are full of holes, knots, textures, and colors. Then the root material suitable for molding is properly treated, peeled, cleaned, set, properly assembled and embellished, and then the upper and lower ends are polished, so that the tire mold is ready. 2, molding. First apply a layer of mold release agent to the tire mold. Generally, use common mold materials (No. 107, No. 106 methyl room temperature vulcanized silicon, cross-linking agent, methyl silicone oil, white latex, etc.); then, use silicone rubber Casting or brushing tire molds, but also for irrigation or immersion mold. After 2 hours at room temperature, it can be vulcanized into a weak rubber to be demoulded, and the root mold can be used after 24 hours. It should be noted that before the rubber mold is demoulded, it must be covered with a fiberglass mold. 3, pouring. First, prepare the mold and apply a mold release agent to the mold. At the same time according to the amount of material used to prepare the raw materials, the raw materials used are unsaturated polyester resins, curing agents, accelerators, diluents, pigments and fillers. When casting, it should be vibrated with stirring to minimize bubbles and trachoma produced during the production process. 4, imitation. After the demoulding, the imitative root blank is properly trimmed to remove burrs. Bubbles and trachoma are filled with the same ingredients. Then the coloring process is applied so that the color of the imitative root carving is the same as the real root carving product. Then, A layer of transparent resin paint is then applied to paint the root pot holder.
Food Sweeteners Chemical Reagent Co., Ltd. , http://www.nsauxiliaryagent.com