Today, we will talk to you about how to install and debug the three-leaf Roots blower.
First, how to install the three-leaf Roots blower.
Because the three-leaf Roots blower is a high-speed machine, it will generate vibration, and because of the pulsation of its internal air, it also increases the vibration of the Roots blower. Therefore, the Roots blower needs to be fixed on the ground during installation.
According to the different fan models, dig a 150*150mm square 300mm square pit at the corresponding position on the ground, and bury the anchor bolts. Then connect the fans with bolts and nuts, and finally fill the square pit with cement. After the concrete is fixed, the nut is tightened, and the nut base and the concrete are firmly connected together, so that the vibration displacement of the Roots blower during operation can be reduced, the operation safety of the equipment is improved, and The vibration is small, which greatly extends the service life of the fan.
Second, the installation should pay attention to:
1. The fan should not be installed in places where people often come in and out to prevent injury and burns.
2. The fan should not be installed in a place prone to flammable, explosive and corrosive gases to prevent accidents such as fire and poisoning.
3. According to the direction of the intake and exhaust ports and maintenance needs, there should be ample space around the base surface.
4. When the fan is installed, it should be checked whether the foundation is firm, whether the surface is flat, and whether the foundation is higher than the ground.
5. When the fan is configured outdoors, a rainproof shed should be installed.
6. The fan can be used for a long time under the ambient temperature of not more than 40 °C. When the temperature exceeds 40 °C, the cooling fan and other cooling measures should be installed to improve the service life of the fan.
7. When transporting air, natural gas, natural gas and other media, the dust content should not exceed 100mg/m3.
Finally, talk about how to debug the three-leaf Roots blower.
1. Check the fastening of each part and whether the positioning pin is loose.
2. There is no oil leakage inside the blower body.
3. There should be no scaling, rust and peeling inside the blower body.
4, pay attention to lubrication and heat dissipation is normal, pay attention to the quality of the lubricant, often listen to the operation of the blower with or without noise, pay attention to whether the unit is operating under the conditions that do not meet the requirements, and pay attention to regular butter.
5, the overload of the blower, sometimes not immediately displayed, so pay attention to the intake, exhaust pressure, bearing temperature and motor current increase trend to determine whether the machine is running properly.
6. Before disassembling the machine, measure the matching dimensions of the machine, make a record, and mark the parts to ensure that the original matching requirements are maintained after assembly.
7. After the new machine or the overhaul blower, the fuel tank should be cleaned and put into operation according to the use procedure. It is recommended to replace all the lubricating oil after 8 hours of operation.
8. Maintenance and overhaul shall be based on the specific use conditions to develop a reasonable maintenance system, on schedule, and make a record, it is recommended to overhaul once a year, and replace the bearing and related wearing parts.
9. The blower overhaul is recommended to be repaired by professional maintenance personnel.
Artificial Insemination Syringe
Artificial insemination Syringe AI GUN
Jinan Mucho Commercial Inc. , https://www.muchovet.com