When the electronic forklift scale weighs the weight, it cannot be biased forward, that is, it cannot exceed the position of the head of the two sensors at the front end. For example, the tray and the tray cannot exceed the fork. For example, the weighing and the error are as follows:
1. Raise the forklift to the maximum, use a piece of paper to insert a circle into the gap between the scale and the fork cover to see if there is any place. If there is a problem, you can use the appropriate tool to tilt off.
2. Raise the fork cover, loosen the sensor retainer, use a large screwdriver to adjust it up, and then install the circlip. If there is no adjustment screw on the sensor, loosen the circlip and then remove the fork cover, then turn the 4 screws in the cover down 2-3 times.
1. Operation
(1) Overloading is strictly prohibited.
(2) Maintain good weighing habits when using. During the weighing process, try to place it in the middle position of the forklift, so that the four sensors of the forklift are balanced. Do not place goods such as pallets on the front end of the fork for weighing, resulting in uneven force on the sensor and affecting the service life of the forklift scale.
(3) During the operation, it cannot be quickly lowered under heavy load to avoid damage to the hydraulic cylinder and the weighing main component.
(4) Under heavy load conditions, the forklift scale is pushed and the hydraulic device cannot be raised.
(5) It is forbidden to perform arc welding on the forklift scale. It is not allowed to use the sensor as part of the arc welding circuit.
2. Use environment
(1) Although the forklift scale meter is treated with waterproofing, it should also be protected against exposure and waterproofing. It is not recommended to take too long in an open air environment.
(2) The front and rear casters are made of polyurethane material and should be avoided on high temperature ground to avoid damage.
(3) Non-special explosion-proof products, please do not use them in flammable and explosive places. Explosion-proof products should also be protected from strong impact when used in flammable and explosive applications to avoid sparks caused by impact.
(4) When charging the forklift scale, please keep away from inflammable and explosive places.
Medical Cold Patch
Patch for diarrhea
[Name] Medical Cold Patch
[Package Dimension] 5cm 4pieces/box
The pain relief patch is composed of three layers, namely, backing lining, middle gel and protective film. It is free from pharmacological, immunological or metabolic ingredients.
[Scope of Application] For cold physiotherapy, closed soft tissue only.
[Indications]
The patches give a fast relief for diarrhea.
[How To Use a Patch]
Please follow the Schematic Diagram. One piece, one time.
The curing effect of each piece can last for 6-8 hours.
[Attention]
Do not apply the patch on the problematic skin, such as wounds, eczema, dermatitis,or in the eyes. People allergic to herbs and the pregnant are advised not to use the medication. If swelling or irritation occurs, please stop using and if any of these effects persist or worsen.notify your doctor or pharmacist promptly. Children using the patch must be supervised by adults.
[Storage Conditions]
Store below 30c in a dry place away from heat and direct sunlight.
Patch For Diarrhea,Medicated Patches For Arthiritis,Plaster For Diarrhea,Pad For Diarrhea
Shandong XiJieYiTong International Trade Co.,Ltd. , https://www.xjplaster.com