Mechanized straw returning technology is a time-saving, high-efficiency and environmentally-friendly advanced technology. When operating, it must follow the instructions of the user's manual to grasp safety precautions and essentials.
1, before the operation to check the work site, remove bricks, stones, iron wire and other hard materials in order to avoid machine damage and personal injury.
2. Before the work, the lifting machine tool should be lifted to a height of 20-25 cm from the ground, and the power output shaft should be engaged for 1-2 minutes. Then hang the work gear, slowly release the clutch pedal, and simultaneously operate the hydraulic lift adjustment. The handles will gradually reduce the returning machine to the required height of the stubble, and then increase the throttle to normal operation.
3, according to crop growth, soil moisture content and firmness, choose different operating speeds. In principle, it is necessary to ensure that the tractor is neither overloaded nor operationally efficient. The crops are growing well, and the planting distance is relatively close. Slower advances should be used. Under normal circumstances, the tractor uses slow three or slow four forward speed, the second time the speed can be increased accordingly.
4. Do not use hammer claws to hit soil during operation. Do not use it as a rotavator. If you find hammers or slings to hit the soil, you should adjust the height of the ground or the length of the suspension rod on the tractor.
5. The turning machine should be lifted when turning and landing after turning. When lifting, landing should pay attention to stability, work is prohibited from retrogression, road transport must be cut off after the tractor output power.
6, the operation should be timely to remove the machine wrapped around the grass, avoid obstacles such as soil, tree stumps, the head to stay 3-5 meters of the unit turning zone.
7. If abnormal noise is heard during the operation, stop and check immediately, and continue the operation after troubleshooting.
8. When the equipment is in operation, it is forbidden to stand on or near the rotating parts to ensure personal safety.
9. The tightness of the belt should be inspected at any time during the operation so as not to reduce the spindle speed and affect the crushing quality and exacerbate belt wear. It is generally preferable to use a 10 kg force to press the belt body down by 5 mm.
10. When the blade is worn out, it should be replaced in time. When replacing the blade, a group of blades with the same weight should be selected to replace the old blade at the same time so as to maintain the balanced operation of the blade shaft and reduce the vibration of the tool.
Multi Enzyme,Feed Additives Enzymes,Feed Enzymes,Nsp Enzyme
Tangshan Finely Animal Care Co.,Ltd , https://www.faczyme.com