In order to effectively control various diseases and weaning syndromes of newborn piglets, improve the survival rate of piglets, and support the development of immune organs and immune function, attention should be paid to the following points when raising piglets:
First, let the pig eat colostrum. Piglets do not have innate immunity and must be obtained through colostrum. The digestive ability of piglets is weak, and gastric digestion fluid lacks hydrochloric acid. Colostrum is extremely nutritious, contains a lot of protein, milk fat, high acidity, and antibodies, can promote digestive tract activity of piglets, and meet the needs of growth and development of piglets. Therefore, after the piglets are born, the piglets should be allowed to eat and eat enough colostrum as soon as possible. When colostrum is eaten, it is best to take care of the weak piglets, and it is best to fix them in the front row of nipples to improve the balance development and survival rate of the whole litter of piglets.
Second, control the ambient temperature. The optimal environmental temperature for newborn piglets is 32°C, and the suitability for 7-day-old piglets is 25°C to 30°C. If the conditions do not meet the conditions, the incubator, infrared lamp, electric heating plate and pad can be used when the temperature is too low. Raise the temperature in the grass, etc., and lower the temperature with a fan when the temperature is too high.
Third, add trace elements. Iron is an important component of heme. Newborn piglets store very little iron. The daily requirement is 7 milligrams to 8 milligrams. The amount available from breast milk is also limited. Therefore, if pig iron cannot be supplemented in time, it will result in Piglets suffer from anemia.
Fourth, do a good job fostering, and nest. Before fostering the nests, use the milk of the foster sow (does not recommend using sow's urine) to wipe the whole body of the piglet or use liquid medicine, such as alcohol, Lysol sprayed on the mother and piglet. Choosing to mix at night will make it impossible for the sow to distinguish between self-produced or fostered piglets. Observe afterwards to prevent sows from refusing to breastfeed or bite to send piglets. Piglets fostered and nested require similar maturities, preferably no more than 3 days to 4 days.
Fifth, disease prevention and treatment. Before the consumption of colostrum, the vaccine can be administered at a conventional dose to the swine fever vaccine, which is commonly referred to as preemptive immunization. After 2 hours, the piglets are allowed to feed freely. In addition, oxytetracycline can be given to sows to prevent piglets from developing red and jaundice. The sheds should be cleaned daily to keep them clean and dry. The piglets should be provided with a hygienic, quiet and fresh air environment. Every day they must observe carefully and find that there are diarrhea and abnormalities.
Joist Tape Deck Flashing Tape Butyl Joist Tape for Decking
The Joist Tape is a malleable polyethylene waterproof wood flashing and material, using a rubberized asphalt mastic adhesive. Rot is caused by moisture that stays in contact with treated and untreated lumber deck framing and the above decking material. Wood decay can also occur when deck screws penetrate the deck boards, piercing the joist sub-framing below. The deck joist tape is easily apply to decking joists, around deck support posts and over ledger boards, which creates a waterproof seal that helps stop decay and wood rot.
The joist tape for decking as a barrier, it can reduce moisture damage to crossbeams. The joist butyl tape is used in temperatures range of -20°F to 176°F, it protects and maximizes the life of your new deck and creates a waterproof membrane that prevents wood rot caused by moisture.
Product Name
Material
high-density polyethylene (HDPE)
Adhesive
Pressure Sensitive
PE Film
White, other colors can be customized
Butyl Rubber
white, other colors can be customized
Application
Butyl Joist Tape
Providing corrosion protection
How To Use The Joist Tape for Decking
The joist tape for decking is easy to install just in seconds. Clean the adherend surface, cut the appropriate length as needed, peel off the protected film, and carefully press the tape against target area. Mistakes are easily rectified within the first few minutes of installation.
Joist Tape,Deck Joist Tape,Joist Tape for Decking,Joist Tape for Decks,Butyl Joist Tape
Kunshan Jieyudeng Intelligent Technology Co., Ltd. , https://www.yuhuanptapes.com